Home | Home & Garden
One of the easiest and less costly ways for you to make a useful improvement in your home is to do faucet replacement, which is to replace an old faucet with a new one. Doing so will eliminate the occurrence of irritating leaks and drips, and it could make an amazing difference in improving the aesthetics of an older room. One of the first things you have to consider in faucet replacement is choosing the right faucet. Nowadays, there are many faucets available in the market that comes in a variety of types, styles, and combinations. But no matter, the first thing you should be worried about is whether the new faucet will fit the old sink. Also keep in mind that for supply connections, there are two possibilities. Your faucet could either have flexible copper supply inlets found in the center of the unit, or the inlets could be located under the hot and cold handles. Before anything else, shut off the main water supply. You can do this by shutting off the control valve found under the sink. It is also recommended that you prepare all the necessary materials beforehand, and don't forget to prepare some penetrating oil in case the mounting nuts are hard to remove, and are stuck. It is also best if you have someone around to help you in handing out the tools as you work. Also, don't forget to plug the drain with rags so that small parts like screws and bolts cannot go down the drain. - Remove the old fixture First, remove the nuts that attach the hose to the faucet body and the spray head to the sink (if you're using a faucet with sprayer). Remove supply lines and set them aside. Remove the mounting nuts that hold the faucet body to the sink. Use your wrench for this. If mounting nuts are difficult to pry loose, use penetrating oil. Detach the faucet. Clean the sink top by scraping putty and mineral deposits away from it. - Attach new faucet to the sink You can use a rope of plumber's putty or install a gasket either to the sink or to the faucet. Put the new faucet in place, making sure that it is parallel to the backsplash. Move under the sink and ask someone to hold the faucet for you while you work. Screw on a washer and mounting nut on every inlet, and tighten using basin wrench. - Connect supply lines Apply pipe joint compound onto inlet threads or you can choose to wrap them with Teflon tape. Twist the supply line nut onto the inlet, tighten it using a hand at first, and then with a wrench. Join the other end of the supply line to the control or shutoff valve in the same method. If flexible copper inlets are used for water supply, the same applies, except that you have to ascertain that no copper tubes are twisted. The faucet could become destroyed if copper tubes are twisted. - Connect and adjust the pop-up drain assembly Insert a ball rod into the opening located in the drain body. Use the nut provided to secure it. Then, slip the rod through clevis strap and use spring clips to secure it. Lower the rod and let it pass through hole near the rear of the faucet sprout and up to the upper end of clevis strap. Tighten thumbscrew lightly at first, adjust rods, and once adjusted, tighten thumbscrews more to set everything in place. And those are the steps to faucet replacement. It may look hard, but once you're at it, everything will become much easier. So, give it a try!
Article Source: http://www.associatedigest.com
Find out how to fix a leaky faucet yourself. Get your step-by-step guide to faucet replacement now!
Please Rate this Article
5 out of 54 out of 53 out of 52 out of 51 out of 5
Not yet Rated
